Printing on Special Paper
CAUTION:
l
When printing multi-part forms, make sure the printing
stays entirely within
the
printable area of the forms.
(For more information on the printable area, see
Chapter 7.)
l
Use four-sheet thick multi-part forms only under
normal operating conditions.
l
Load single-sheet multi-part forms from
the
front only.
Labels
When printing labels, always choose the type mounted on a
continuous backing sheet with sprocket holes for use with a tractor.
Do not try to print labels as single sheets because labels on a shiny
backing sheet do not feed properly.
It is recommended you load labels from the front or bottom paper
slots with the tractor in the pull-tractor position. You load labels
the
same way that you load continuous paper (with the pull tractor), except
you set the paper-thickness lever to position 2.
See Loading continuous paper with the pull tractor earlier in this
chapter for details.
CAUTION:
l
Never feed labels backward with the
LOAD/EJECT
or
TEAR OFF
buttons. Labels can easily peel off the
backing and jam
the
printer.
l
Since labels are especially sensitive to temperature and
humidity, use them only under normal operating
conditions.
l
Do
not
leave labels loaded in the printer between jobs;
they
curl around the platen and may jam when you
resume printing.
l
To remove labels from the paper path after you finish
printing, first tear off
the
labels at a point before the
paper slot. Then
use
the
LF/FF
button to advance the
remaining labels out of the printer.
Paper Handling
2-25
