Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
Page 63 of 73
IMPORTANT
If the model doesn’t begin to separate easily, move to a different area, working your way around the
model until it safely dislodges from the build platform.
IMPORTANT
Close the printer door after removing the build platform.
11.4
Resetting the Printer After a Print
1. Once the models have been removed, use the scraper to remove any remnants of the printed job from the
surface of the build platform.
2. Wipe the entire platform dry using a paper towel. The previous print job shouldn’t be visible on the platform.
3. Install the build platform on the printer and tighten the build platform knob.
4. Close the hood.
→
The Envision One can now begin printing the next loaded print job.
11.5
Cleaning Printed Models and Removing Supports
The PWA 2000 Parts Washing Apparatus is the recommended washing unit for the Envision One. To get the
information on how to clean a printed model with PWA 2000, check the corresponding
PWA 2000 Technical Guide
provided with your PWA 2000, if ordered.
REFERENCE
For information on cleaning of the printed models, consult the Material Best Practice guide or
Instruction of Use provided by your manufacturer or distributor.
11.6
Post-curing the Printed Models
The PCA 2000 Parts Curing Apparatus is the recommended curing unit for the Envision One. To get the information
on how to cure a printed model with PCA 2000, check the corresponding
PCA 2000 Technical Guide
provided with
your PCA 2000, if ordered. The Otoflash is the recommended curing unit for materials used in medical applications.
REFERENCE
For information on cleaning of the printed models, consult the Material Best Practice guide or
Instruction of Use provided by your manufacturer or distributor.
11.7
Finish Post-processing of a Printed Model
Finishing is the final step in post processing a printed model. With finishing, grind all traces of supports and polish
models as needed, depending on the final part application.
1. Grind support bumps using a fine burr and rotary tool, or manually using sandpaper.
2. Remove dust particles by quickly spraying the model(s) with 99% IPA in a spray bottle, and dry immediately
with compressed air.
