Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
Page 25 of 73
7.3
Installing Envision One Domeless Material tray
To install the material tray:
1. Unscrew the two torque knobs on the right and left of the build area.
2. Slide the domeless material tray into the printer, vent holes first, until it is fully
seated. Listen for the click.
3. Tighten the two torque knobs by turning them to the right until they
are snug, and the material tray is secure. Listen for the click.
IMPORTANT
Tightening the two torque knobs until they are snug is very important. If they are not secured
properly, the material will splash inside the printer!
Double-check if the torque knobs are tightened securely before starting a build process!
7.4
Adding the Material
Each type of material EnvisionTEC offers has the Material Best Practices guide.
Be sure to properly prepare your specific material before each use. Always observe the relevant
supplied with the material bottle.
IMPORTANT
Use the appropriate personal protective equipment.
IMPORTANT
Make sure that the extraction is sufficient. EnvisionTEC® recommends an air change of 25 m
3
/h per
m
3
effective surface of the laboratory as described in EN 13779.
IMPORTANT!
Risk of damage to the printer!
It is important to always remove the build platform before taking the material tray assembly out of the
printer!
Failure to do so can result in material dripping down into the safety glass causing failed builds and
ruined equipment!
IMPORTANT
Use a different tilt material tray for each kind of material to avoid contamination. If not possible, clean
the tilt material tray carefully and thoroughly.
IMPORTANT!
Risk of damage to the printer!
Never fill the domeless material tray over the top of the material tray ramp as it will result in material
spilling out and into the printer.
Step-by-step:
1. Open the printer
′
s hood.
2. A material tag is attached to the material bottle. Remove the material tag and place the material tag on
the material tag reader.
3. Shake the material bottle well. Open the material bottle and pour the material slowly into the material
tray to the material fill line.
4. Mix the material thoroughly with the supplied spatula. Close the hood to protect the material from ambient
light.
7.5
Connecting the Oxygen Concentrator to the Printer
Prerequisite:
The oxygen concentrator has been set up following the steps in
Setting up the Oxygen Concentrator
section.
IMPORTANT
The printing must finish before plugging the oxygen concentrator into the printer.
Figure 13. Material tray installation
