Bootrom Monitor Mode Commands
XSR Getting Started Guide 3-41
sf
This command shows a fault report. Sample output is shown as follows:
XSR-1800: sf
No fault report at 0x1feef00
si
This command displays system inventory. Sample output is shown as follows:
XSR-1800: si
IBM PowerPC 405GP Rev. D
Processor speed = 200 MHz
PLB speed = 100 MHz
OPB speed = 33 MHz
Ext Bus speed = 25 MHz
PCI Bus speed = 33 MHz (Sync)
Internal PCI arbiter enabled
RAM installed: 32MB
Flash installed: 8MB on processor board
CompactFlash: SunDisk SDP 5/3 0.6 has 32047104 bytes
Real Time Clock
FastEthernet 1
FastEthernet 2 Rev 0
H/W Encryption Accelerator Rev 1
T1E1 has 4 channelized ports on NIM slot 1. Rev 0
ISDN BRI has 2 ST ports in NIM slot 2. Rev 1
Empty internal NIM slot 3
System up for 345 seconds.
sn
This command shows network values with the following sample output:
XSR-1800: sn
wLocal IP address : 10.120.112.33
Gateway IP address :
Remote IP address : 10.120.112.88
Remote file path :
Transfer Protocol : TFTP
Local target name : robo1
Autoboot : enabled
Quick boot : no
Current FastEthernet 0 MAC address is: 00:01:f4:01:01:01
Current FastEthernet 1 MAC address is: 00:01:f4:01:01:02
