XSR Rebooting Characteristics
XSR Getting Started Guide 3-35
Verifying uncompressed chksum ...
Starting at 0x10000...
Attached TCP/IP interface to Eth unit 1
Attaching interface lo0...done
cflash:/ - Volume is OK
Restoring startup configuration files, please wait
Startup configuration files have been restored.
login:
Reboot Triggers
Although there are two types of reboots of the XSR - warm or cold - reboots can be triggered in up
to eight different ways. Refer to the table below.
Power-Up Reboot
If you power cycle the XSR by flipping the switch on the back panel, the XSR will cold reboot. The
startup-config
file stored in Flash becomes the running configuration.
Reload Command from the CLI
You can reboot the XSR firmware by issuing the command
reload
<cold | warm>
. You are then
prompted to confirm the command. Once the firmware is reloaded, the configuration is loaded
from the startup-config file.
Bootrom Monitor Commands bc and bw
Using Bootrom Monitor mode, you can activate warm or cold reboots by entering
bw
or
bc
,
respectively. Refer to
“Bootrom Monitor Mode Commands”
on page 3-36 for more data.
Table 3-1 Reboot Types
Cause
Boot Type
Power-up
Cold
CLI reload
Cold or Warm
SNMP reload
Cold or Warm
Watchdog Expiration
Warm
Software Crash
Warm
Repetitive Software Crash
Cold
ROM Monitor
Cold or Warm
Invalid SW text checksum
Warm
