Bootrom Monitor Mode Commands
3-40 Software Configuration
np
This command modifies network parameters. You are prompted to enter data by the following
script. While most of the options are self-explanatory, three require further description.
•
When set to
no
, the
Autoboot
option places the prompt in Bootrom mode when you boot or
power up the XSR.
•
When set to
yes
, the default
Quickboot
action of delaying five seconds at startup for you to
optionally enter CTRL-C and acquire Bootrom mode is negated. You can still acquire Bootrom
mode, but you must immediately press CTRL-C upon seeing the
X-Pedition Security Router
Bootrom
header.
•
The default hostname (local target name),
XSR-1800
, cannot be changed. In the absence of a
user-supplied hostname via the
hostname
CLI command, this name will be used as the CLI
prompt and SNMP hostname in MIB-II.
XSR-1800: np
Enter ‘.’ = clear a field; ‘-’ = go to previous field; ^C = quit
Local IP address (192.168.1.1) :
Gateway IP address () :
Remote Host IP address (192.168.1.10) :
Remote file path (c:\) :
Use TFTP (no) :
Ftp userid (anonymous) :
Ftp password () :
Local target name () :
Autoboot (yes) :
Quick boot (no) :
Permanently save the network parameters? (y/n)
ns
This command saves a file over the network using a remote IP address/file path.
remove
This command removes a file using the syntax
remove <source name> <destination name>
rename
This command renames a file using the syntax
rename <source name> <destination name>
sb
This command displays boot values. Sample output is shown as follows:
XSR-1800: sb
Current boot file is xsr1800.fls
Boot selector default is flashrom, compactFlash, network
Available Network boot devices: Eth1
