Enterasys Vertical Horizon VH-2402S2, Configuration Manual

Page: 43 / 116

9033820-03
VH-2402S2 User Interface 35
You can use the Port Trunking Configuration screen set up port trunks as
shown below:
Figure 2-24. Port Trunking Configuration
The RJ-45 ports used for each trunk must all be on the same internal
switch chip. The port groups permitted include:
Group 1 Group 2 Group 3
1,2,3,4, 5,6,7,8, 9,10,11,12,
13,14,15,16 17,18,19,20 21,22,23,24
Only two 100Mbps fiber ports can be configured as a trunk and these
must be on the same module. 1000Base-SX/LX ports can be trunked
together with any other like uplink ports in the stack.
Vertical Horizon Stack Local Management
Port Trunking Configuration
Trunk ID Status Member List
1 2 3 4
--------- -------- ----------- ----------- ----------- -----------
-- -------- Unit : - Unit : - Unit : - Unit : -
Port : -- Port : -- Port : -- Port : --
-- -------- Unit : - Unit : - Unit : - Unit : -
Port : -- Port : -- Port : -- Port : --
-- -------- Unit : - Unit : - Unit : - Unit : -
Port : -- Port : -- Port : -- Port : --
Trunk ID : 1 Trunk ID : 1 Member Unit : 1
Member Port : 1
[Show] [More]
[Enable] [Disable] [Add] [Delete]
<OK>
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter Description
Trunk ID Configure up to five trunks per standalone switch, or up to 12 for
an entire stack.
Unit Specifies a switch unit in the stack (1~7).
Port Select from 2~4 ports per trunk.
[Show] Displays trunk settings, where the first trunk listed is specified by
“Sorted by Trunk ID.”
[More] Scrolls through the list of configured trunks.
[Enable] [Disable] Enables/disables the selected trunk.