Enterasys Vertical Horizon VH-2402S2, Configuration Manual

Page: 76 / 116

68 VH-2402S2 User Interface VH-2402S2
Configuring Static Unicast Addresses
Use the Static Unicast Address Table Configuration screen to manually
configure host MAC addresses in the unicast table. You can use this
screen to associate a MAC address with a specific VLAN ID and switch
port as shown below.
Figure 2-53. Static Unicast Address Table Configuration
Vertical Horizon Stack Local Management
Static Unicast Address Table Configuration
VID MAC Address Unit Port Status
------------------------------------------------------------
Sorted by : VID + MAC VID : 1 MAC : 00-00-00-00-00-00
VID : 1 Unit : 1 Port : 1
MAC : 00-00-00-00-00-00 Status : Permanent
[Show] [More] [Set]
<OK>
Use <TAB> or arrow keys to move. <Enter> to select
Parameter Description
VID The VLAN group this port is assigned to.
MAC Address The MAC address of a host device attached to this switch.
Unit The switch unit the host device is attached to.
Port The port the host device is attached to.
Status The status for an entry can be set to:
Permanent:
This entry is currently in use and will remain
so after the next reset of the switch.
DeleteOnReset: This entry is currently in use and will remain
so until the next reset.
Invalid: Removes the corresponding entry.
DeleteOnTimeOut: This entry is currently in use and will remain
so until it is aged out. (Refer to Address Table
Aging Time on page 66.)
Other: This entry is currently in use but the
conditions under which it will remain so differ
from the preceding values.
[Show] Displays the static address table sorted on VID as the primary key
and MAC address as secondary key.
[More] Scrolls through entries in the static address table.
[Set] Adds the specified entry to the static address table, such as
shown in the following example:
VID : 1
MAC : 00-00-00-e8-34-22
Unit : 1 Port : 1
Status : Permanent