Enterasys Matrix 7G4202-30, Hardware Installation Manual

Page: 71 / 110

Completing the Installation
Installation 3-35
First-Time Log-In Using a Console Port Connection
Start the Command Line Interface (CLI) from the module’s local console port as follows:
1. Connect a terminal to the local console port as described in Section 3.8 . The startup screen,
Figure 3-20 , displays.
2. At the login prompt, enter one of the following default user names:
•
ro for Read-Only access,
•
rw for Read-Write access, or
•
admin for Super User access. (This access level allows Read-Write access to all modifiable
parameters, including user accounts.)
3. Press ENTER.
4. The Password prompt displays. Leave this string blank and press ENTER. The module
information and Matrix prompt displays as shown in
Figure 3-20 .
The DFE module is now ready to be configured. For information about setting the IP address and
configuring Telnet settings for remote access to DFE management, refer to Chapter 3 in the
Enterasys Matrix DFE-Platinum Series Configuration Guide . The CLI commands enable you to
initially set up and perform more involved management configurations.
The Enterasys Matrix DFE-Platinum Series Configuration Guide is available online at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described in
“
Getting Help ” on page xxii.
Note: This procedure applies only to initial log-in, and to logging in to a device not yet
configured with administratively-supplied user and password settings.
By default, the Matrix DFE Series device is configured with three user login accounts: ro
for Read-Only access; rw for Read-Write access; and admin for super-user access to
all modifiable parameters. The default password is set to blank (carriage return). For
information on changing these default passwords, refer to
Chapter 3 in the
Enterasys
Matrix DFE-Platinum Series Configuration Guide
.