Enterasys Matrix 7G4202-30, Hardware Installation Manual

Page: 38 / 110

Unpacking the DFE Module
3-2 Installation
3.1 UNPACKING THE DFE MODULE
Unpack the DFE module as follows:
1. Open the box and remove the packing material protecting the DFE module.
2. Verify the contents of the carton as listed in Table 3-1 .
3. Remove the tape seal on the non-conductive bag to remove the DFE module.
4. Perform a visual inspection of the DFE module for any signs of physical damage. Contact
Enterasys Networks if there are any signs of damage. Refer to “
Getting Help ” on page xxii for
details.
3.2 INSTALLING AN OPTIONAL NETWORK EXPANSION MODULE
Refer to your release notes or the Enterasys Networks web site for the latest available network
expansion modules (NEMs).
A Phillips screwdriver is required to install an optional NEM into the 7H4382-49 or 7H4383-49
DFE module.
Installing a NEM involves
• removing the coverplate from the DFE module (7H4382-49 or 7H4383-49),
• attaching the NEM to the DFE module, and
• installing the Mini-GBICs.
Refer to the installation instructions shipped with the NEM for details.
Table 3-1 Contents of DFE Module Carton
Item
Quantity
DFE module (7H4382-49, 7H4383-49, 7G4270-12, 7G4202-30, or 7H4203-72) 1
Installation Guide 1
Customer Release Notes 1
Note: Install any optional equipment before proceeding to Section 3.4 for an explanation
of the rules to install different series modules in a Matrix E7 chassis.