Enterasys Matrix 7G4202-30, Hardware Installation Manual

Page: 100 / 110

Memory Locations and Replacement Procedures
B-8 Mode Switch Bank Settings and Optional Installations
Figure B-8 Removing the Existing DRAM SIMM from 7H4382-49 or 7H4383-49
Installing the DRAM SIMM on 7H4382-49 or 7H4383-49
To install the memory module, refer to Figure B-9 and proceed as follows:
1. With the connector arms set in the open position, insert the memory module between the
connector fingers and push the memory module into the connector until the tabs on the two
connector arms pull in towards the DRAM SIMM alignment notches.
2. Push the DRAM SIMM further into the connector until the two DRAM SIMM alignment
notches and the tabs on the two connector arms lock the DRAM SIMM into place.
1
Connector arms
2
Memory module
3
Connector
Caution: Observe all antistatic precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
Â
À
À
Á