Installing an Optional Mini-GBIC
3-4
Installation
2.
Remove the Mini-GBIC from the packaging.
3.
If there is a protective dust cover (see 5 in
Figure 3-1
or
Figure 3-2
) on the Mini-GBIC port, do
not remove it at this time.
Installation
To install a Mini-GBIC with an MT-RJ connection, refer to
Figure 3-1
, for an LC connection, refer
to
Figure 3-2
, or for an RJ45 connection, refer to
Figure 3-3
, and proceed as follows:
1.
Hold the Mini-GBIC with its top side facing up and its 7-pin edge connector facing the port
slot .
2.
Carefully align the Mini-GBIC with the port slot .
3.
Push the Mini-GBIC into the port slot until the Mini-GBIC “clicks” and locks into place.
Figure 3-1
Mini-GBIC with MT-RJ Connector
1
Mini-GBIC (MGBIC-MT01)
4
Port slot
2
Mini-GBIC
,
top side
5
Mini-GBIC
,
protective dust cover
3
7-Pin edge connector (insertion side)
6
Release tab
À
Á
Ã
Â
Å
Ä
Summary of Contents for Matrix 7G4202-30
