~37~
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
destination handsets will be opened up
d. Release “PTT” key to end the broadcasting
3. Broadcasting an individual handset
a. Enter the Handset ID and then press "PTT” key
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
destination handsets will be opened up
d. Release “PTT” key to end the broadcasting
Making a Broadcast via UHF
A. Handset to UHF walkie-talkie
1. Activate walkie-talkie mode
a. Enter the key sequence
MENU
- 5 - # - 1, then select
“ON” to enable the WT mode in analog UHF band.
After press “End” to back idle mode. You can see
the display with a walkie icon.
2. Broadcasting all UHF walkie-talkie handsets
a. Ensure the same setting for channel/
Frequency/Code before doing the broadcast
b. Press “PTT” key, the display will show channel and
transmitting a broadcast to all handsets within
communication coverage
c. Start to speak the message to be broadcasted
immediately; the speakerphone of destination
handsets will be opened up
d. Release “PTT” key to end the broadcasting
Scanning via UHF
The Scan feature is to check continuously for activity on the channels. You should
activate which channels desired to scan in walkie programming mode. You can scan
up to 5 channels as settings. When the radio detects activity, it stops scanning and
locks it on the active channel.
11
PA paging
to Ext. # 12
10
PA paging
to Ext. # 12
10
1
DuraFon PRO
REDIAL
MENU
~38~
1. Enter programming mode via pressing and hold MODE
key while turning the radio on.
Press “MODE” key 6 times to enter the scan channel
setting. You can use “Up” or “Down” key to select which
channel to be scanned
2. Press “Left” soft key to enable/disable this channel
scanning
3. Press “END” key to exist the setting.
To begin scanning:
4. During IDLE mode, press and hold the “MODE” key for 3
seconds to start the scan. the radio begins to scan the
channel. You can see the scan icon and rolling channel
number.
When the radio detects activity, it stops scanning till
without signal.
5. You can rotate knob clockwise to increase and
counterclockwise to decrease volume
To stop scanning:
6.
.
During IDLE mode, press and hold the “MODE” key for 3
seconds to end the scan.
Monitoring via UHF
You can use monitoring feature to check the activity on the channel. The squelch
will be opened to unmute the speaker; you can check another party is using the
same channel.
To begin scanning:
1. During IDLE mode, press and hold the
key for 3
seconds to start monitoring the current channel. You
will hear static and show receiving icon on display
To stop scanning:
2.
.
press and hold the
key for 3 seconds to end the
monitor.
10
4
Scan Channel
Off
10
4
Scan Channel
On
1
1
10
Du
raFon PRO
REDIAL
MENU
Z
4
10
Du
raFon PRO
REDIAL
MENU
4
