~31~
User capacity can be increased by adding additional base units.
Up to 8 base units can be supported.
Re : Handsets can answer calls from any port or line, unless port is dedicated to
a specific handset or group.
1. Handset Registration.
a. Press
REG
button on Base 00(default), four LEDs will light up in
setting mode
b. Handset operation: Press
MENU
6
1
. (It will complete the
registration process)
c. Repeat, as needed, to add handsets
2. Establishing additional Base Units:
a. Press REG button on new Base.
b. Use Handset 10 or 11 to Add base :
Press
MENU
8
1
Enter 01~07 (base ID)
c. Repeat, as needed, to add base units
Notes:
1. Only Handset 10, 11 can assign Base ID.
2. Base 00 is a primary base. All handset must register only on Base 00.
3. To avoid interference, the interval between any two bases should be
at least 10 meters.
Legacy
PBX
1
Base-1
Base-2
Base-3
2 3 4
1 2 3 4
1 2 3 4
10
Select Mode:
1. Add Base
10
Added Base
Number : **
CANCEL
~32~
Handset and Charger Installation
1. Plug the transformer end of the Charger AC/DC adaptor into a standard AC
electric power outlet, plug the other end into the “DC In” jack on the back of
the Charger.
2. Install battery pack onto the handset.
3. Install handset antenna.
4. Place handset onto the charger front slot.
5. Fully charge the battery for three hours before use.
6. The phone system is now ready to perform basic functions such as making and
receiving phone calls and intercom calls. No base station or handset
programming is needed for basic operations.
Note:
1.
Handset(s) packaged along with a Base Station are pre-
registered at the factory. If you have a new handset, you will
need to register the handset with the base station in order to
be recognized as a member handset by the base(s) and by
other handsets. See Handset Registration.
2.
Fully charge battery packs before the first usage.
