ENFORCER Indoor Proximity Card Reader
SECO-LARM U.S.A., Inc.
3
Dimensions and Overview:
Installation:
1.
Unpack the unit and familiarize yourself
with the proximity card reader.
2.
Test the mounting location of the proximity
card reader for fit.
3.
Using a Philips screwdriver, remove the
screw from the bottom of the proximity card
reader and separate the outside case from
the base.
4.
Place the base on the mounting location
and then mark the locations of the two
mounting holes and two wire holes.
5.
Drill a
1
/
2
” hole in the mounting location
through which wires can be run to the
proximity card reader.
6.
Permanently screw the base to the
mounting location.
7.
Run the wires from the power supply,
egress button, door unlocking device, and
other accessories as needed through the
hole to connect to the terminal block.
8.
Connect the appropriate wires to the
proximity card reader’s terminal block.
9.
Reattach the proximity card reader’s
outside case to the base.
10.
The preliminary installation is done. The
proximity card reader is ready to power up
and program.
Mounting Diagram:
Front view
Back view (cover removed)
Operation
indicator LEDs
Status LED
(blue)
Card reader
window
Doorbell
button
Door lock
selection jumper
Terminal
block
Tamper
switch
CMC
Jumper
2
3
/
8
” (60mm)
4
3
/
4
" (
12
0m
m
)
7
/
8
”
(23mm)
Front View
Side View
1
1
/
16
” (27mm)
3
5
/
16
" (8
4m
m
)
Base
Proximity
card
reader
Mounting
screw
Wire
holes
Mounting
screw
