ENFORCER Indoor Proximity Card Reader
10
SECO-LARM U.S.A., Inc.
Advanced Programming:
This section includes complete programming information. For a typical installation that does not
need full programming, see Basic Programming (page 8).
Adding User Cards:
The ENFORCER Proximity Card Reader can learn up to 500 user cards. This memory is divided
into five user card groups, each of which holds a maximum of 100 user cards.
For a simple installation, all of a company’s users (up to 100) can be put into the same user card
group. Alternately, they can be split between two or more groups to make it easier to delete an
entire group’s user cards at once. For instance, user cards given to a group of temporary workers
could be programmed into their own user card group. All the cards in that group can then be
deleted once the workers leave.
Step Action
Reaction
1
Tap the master card 1 time
Blue status LED flashes, and LED 1
flashes once
2
Wait 2 seconds
2 Beeps, then LEDs 1 through 5 flash
3
Press the “Bell” button one or more times
to choose a user card group from 1 to 5
The LED corresponding to the chosen
user groups turns to a steady ON to
indicate that the user group is ready to
receive user card codes; if the LED
flashes, that user card group is full and
cannot accept new cards
4
Wait 2 seconds
2 Beeps
5
Tap a blank user card 1 time
2 Beeps
6
To add multiple user cards, repeat step 5,
or steps 3-5 to add to other groups
2 Beeps for each card confirms that the
card was programmed into the reader
7
Exit programming by tapping the master
card once
2 Beeps
NOTE:
Once a user card has been programmed into the reader, it cannot be added to the same or
another user card group. A long beep indicates that the user card is in use and will not be
added a second time.
