23/34
TEC/TEM owner manual
5.0 Programming mode (Thermal Energy Monitor)
Your installer will automatically program the communication
address on the Thermal Energy Monitor so that data can be exchanged.
The only reason that this address would need to be changed for
the Thermal Energy Monitor that was included with your appliance is if
the Thermal Energy Controller had its address changed by the installer.
You may also have multiple Thermal Energy Monitors in your
home for displaying information from one Energy Pack. In this case,
they must all share the same address to display your information
correctly.
To change communication address, press and hold
up
and
down
buttons
simultaneously
for
five seconds
. Screen will change to one similar to that
seen below, with your communication address (this one says 3A8D with a
lowercase “d”):
Figure 5.0
Use
up
button to
change
value and
down
button to
accept
. Characters
change from left to right. After entering final character, let Monitor sit for a
minute and it will resume normal operation.
Up button
Down button
