^SynOhrMultiSenseKNX-Eng-13.odt, 2014-05-06 Page 6 of 49
Use of the dot matrix for the display of symbols (from Q3/2014)
-
-
Yes
Speech wildcard commands
One command „DIMMER_PERCENT“ can control in this way the
brightness of a KNX
TM
Dimmers completely
-
-
Yes
Conversion of the color change
-
-
Yes
Master/Slave mode, if multiple switching points in larger rooms
available (Enertex® EibPC required)
-
-
Yes
The variants are software options that are enabled on the serial number of the device and have
to be licensed for the device.
KNX
This device is a product of the KNX-system and complies with the KNX directives. Detailed
technical knowledge obtained in KNX training courses is a prerequisite to understanding. The
software for the KNX
TM
part is in the product data base. Planning, installation and commissioning
are carried out with the help of KNX-certified software. The built-in speech is parameterized
using the freely available program SynOhrStudio. You will find the required data under
. The device is powered only from the bus and does not require additional
auxiliary power supply.
If reducing the bus voltage below 23V, then a flicker of light occurs if this is set to maximum
value. Reduce in this case the illumination (s. p.11).
Installation
In the installation box (Picture 2), which is installed in a standard hollow wall box, the bus
coupler is integrated. This is in addition to the communication to KNX
TM
bus also produces the
power to the SynOhr MultiSense KNX main module. The exact procedure in the assembly, refer
to the Quick Start Guide.
Picture 2: Dimensions of the Installation Box – Bus Coupler
Enertex
®
Bayern GmbH – Ebermannstädter Straße 8 - 91301 Forchheim - [email protected]
