Energie FF Evi 10, Installation And Instruction Manual

Page: 30 / 59

ENERGIE Page | 28
h.
After modification, press “ ” to confirm or “ ” to annul the
modification;
i.
Press “ ” to return to the previous menu;
j.
To save the modifications, press “ ” several time until going back
to the main menu.
ATTENTION
The parameters modified without confirmation via the “ ” key go
back to the previous value;
If no operations are performed on the keyboard for 60 seconds, the
controller exits the parameter modification menu by timeout and
the changes are cancelled.
17.8 Configure/ change cooling and heating set points
Parameter Description
R01 Cooling setpoint
R02
R01 differential
R03 Heating setpoint
R04 R03 differential
To configure the cooling and heating set points in the Heat Pump must
perform the following procedures:
1.
Go to the controller “µC²SE” and following the next steps:
a) Press simultaneously the " " and " " keys during 5 s;
b) Set the password (11) via " " or " " keys and confirm with " "
key;
c) With " " or " " keys select the menu parameter and
enter with " " key;
d) With " " or " " keys select the parameter and enter with
" ". Key;
e) With " " or " " keys go to the parameter r01 (cooling mode
set point) , enter with " " key and set the new set point, save the
value with " " key,
f) With " " or " " keys go to the parameter r02 (cooling mode
differential) , enter with " " key and set the new set point, save
the value with " " key,