Energie FF Evi 10, Installation And Instruction Manual

Page: 28 / 59

ENERGIE Page | 26
17.3
Keypad
Button Unit state Pressure mode
Return to upper level up to exit (with
saving in EPROM)
Single press
Access to parameters type “Direct”.
Selection and display of type “Direct”
parameter value.
Confirm the parameter values/
changes.
Single press
Parameters programming via
introduction of password
Press for 5 s
Alarms manual reset
Immediate timer reset (hour counter)
Press for 5 s
Value decrease
Select previous parameter Single or
continuous press
Immediate access to values read by
the probes
Single press
Value increase
Single of
continuous press
Immediate access to values read by
the probes Single of
continuous press
Switch from stand-by to chiller mode
and vice versa
Single press
Selection of successive parameter Press for 5 s
Start manual defrost Press for 5 s
17.4 Start or stop the unit
Press“ ”last 5 seconds to start or stop unit the LED display as
following
：
If you press“ ”, the unit will be
heating mode;
If you press“ ”, the unit will be
cooling mode;
NOTE: The timings of the compressor have priority over any order
executed on keyboard or thermostats.