Using special
fi
ttings / accessories
External start device
Issued: February 2013
ESE 607 / 957 DBG (ES) DIN
57
5.6
External start device
Proceed as follows to operate the generator using the external
start device.
Requirements
The following requirements must be ful
fi
lled:
●
an operational generator
Connecting up the external
start device
Figure 5-6: Connecting up an external start device
Connect up the external start device as follows:
1. Unscrew cover
(Figure 5-6-(2))
on the external start socket
(Figure 5-6-(1))
.
2. Insert plug for the external energy source connecting cable
(e.g. starter battery) / external start socket into the external
start socket and lock in place by turning to the right.
Remote start device is ready for use.
The engine can be started using the electrical start.
Disconnecting the remote
start device
Disconnect the remote start device as follows:
1. Release the plug by turning to the left and then pull the
external energy source / external start socket plug out.
2. Screw protective cap for the external start socket back on
again.
Remote start device is disconnected.