Endress+Hauser Proline Promass O 100HART, Operating Instructions Manual

Page: 46 / 140

System integration Proline Promass O 100 HART
46 Hauser
Parameter Description Selection / User entry Factory setting
Burst variable 0 Assignment of the individual HART
variables (PV, SV, TV, QV) and assignment
of the process variables available in the
device to the HART command. • Mass flow
• Volume flow
• Corrected volume flow
• Target mass flow
• Carrier mass flow
• Density
• Reference density
• Concentration
• Dynamic viscosity
• Kinematic viscosity
• Temp. compensated
dynamic viscosity
• Temp. compensated
kinematic viscosity
• Temperature
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Sensor integrity
• Pressure
• HART input
• Percent Of Range
• Measured current
• Primary variable (PV)
• Secondary variable (SV)
• Tertiary variable (TV)
• Quaternary variable (QV)
• Not used
Volume flow
Burst variable 1 See burst variable 0. See burst variable 0. Not used
Burst variable 2 See burst variable 0. See burst variable 0. Not used
Burst variable 3 See burst variable 0. See burst variable 0. Not used
Burst variable 4 See burst variable 0. See burst variable 0. Not used
Burst variable 5 See burst variable 0. See burst variable 0. Not used
Burst variable 6 See burst variable 0. See burst variable 0. Not used
Burst variable 7 See burst variable 0. See burst variable 0. Not used
Burst trigger mode Use this function to select the event that
triggers burst message X.
•
Continuous option:
The message is triggered in a time-
controlled manner, at least observing the
time interval defined in the
Burst min
period parameter.
• Window option:
The message is triggered if the specified
measured value has changed by the value
in the
Burst trigger level parameter.
• Rising option:
The message is triggered if the specified
measured value exceeds the value in the
Burst trigger level parameter.
• Falling option:
The message is triggered if the specified
measured value drops below the value in
the
Burst trigger level parameter.
• On change option:
The message is triggered if the measured
value changes.
• Continuous
• Window
• Rising
• Falling
• On change Continuous
Burst trigger level For entering the burst trigger value.
Together with the option selected in the
Burst trigger mode parameter the burst
trigger value determines the time of burst
message X.
Positive floating-point number 2.0E-38