Endress+Hauser Liquiline CA80SI, Operating Instructions Manual

Page: 57 / 172

Liquiline System CA80SI Operation
Hauser 57
Menu/Setup/General settings/Logbooks
Function Options Info
Overflow warnings
Analyzer calibration logbook
= Fill up buffer
Calibration logbook Selection
• Off
• On
Factory setting
Off
‣
Decide whether you want to receive a
diagnostic message if the fill buffer of the
relevant logbook overflows.
Diagnostic logbook
Configuration logbook
Analyzer data logbooks For analyzer measured data
The entry is made automatically on completion
of the measurement. A setting does not need to
be made. The logbook is activated automatically.
SP1 is assigned to data logbook SP1.
Data logbook SP1 Assignment to measuring channel
Source of data Read only The assigned measuring channel is displayed
Measuring parameter Read only Plain-text information on the parameter that is
being recorded
Unit Read only Information about the unit in which the data are
available
Logbook name Customized text, 16
characters
Line plotter Menu to define the graphic display
Axes Selection
• Off
• On
Factory setting
On
Should the axes (x, y) be displayed ( On ) or not
( Off )?
Orientation Selection
• Horizontal
• Vertical
Factory setting
Horizontal
You can choose whether the value curves should
be displayed from left to right (
Horizontal ) or
from top to bottom ( Vertical ). If you want to
display two data logbooks simultaneously, make
sure that both logbooks have the same settings
here.
X-Description Selection
• Off
• On
Factory setting
On
‣
Decide whether a description should be
displayed for the axes and whether gridlines
should be shown. In addition, you can also
decide whether pitches should be displayed.
Y-Description
Grids
Pitches
X Pitch/Grid
distance 10 to 50%
Factory setting
10 %
‣
Determine the pitch.
Y Pitch/Grid
distance