Transport and storage
Automatic Boat Drive
36
Connect the ABD to the analyzer as follows:
}
Connect the mains supply cable to the mains connection on the equip-
ment backplate and to an isolated ground receptacle.
Note
Observe the permitted operating voltage on the type plate.
1
}
Connect the ABD via the serial interface cable to the analyzer:
¡
"RS 232 sampler" interface at the rear of the ABD (1)
¡
Interface „Sampler“ at the rear of the analyzer (2) or via another sampler
module
If the optional flame sensor is used, connect the connection cable between
ABD and analyzer:
¡
Interface "flame" at the rear of the ABD (1)
¡
Interface "flame" at the rear of the analyzer (2)
The flame sensor is located at the combustion tube and is directly connected
to the contact strip inside the analyzer (refer to the user manual of the sam-
pler).