Automatic Boat Drive
Transport and storage
33
8
Transport and storage
8.1
Transport
8.1.1
Preparing the ABD for transport
CAUTION
When removing glass components there is a risk of injury from broken glass!
Use care when removing the glass components from the ABD!
NOTICE
Unsuitable packaging material can cause damage to individual components of the ABD!
Only transport the ABD in its original packaging! Ensure that the sample sluice is com-
pletely empty!
Prepare the ABD for transport as follows:
}
Switch off the ABD from the equipment switch and disconnect the mains plug from
the mains outlet.
}
Remove the interface cable ("RS 232 multi EA" connector) and the flame sensor cable
("flame" connector).
}
Disconnect the gas supply and remove the connection hose 16 from the ABD.
}
If necessary, remove the sampler from the ABD and prepare it separately for trans-
port (refer to the user manual of the sampler).
}
Disconnect the ABD from the basic module (→ "Disconnecting the ABD from the
combustion tube"
27). Loosen the clamp screw at the sample sluice and remove
the ABD connection piece.
}
Place the ABD connection piece with seals and screwed connection in the original
packaging.
}
Remove the protective cover for the guide tube.
}
Remove the hook from the guide tube (→ "Cleaning and replacing the hook at the
ABD"
30) and place it in the original packaging.
}
Carefully package the ABD and accessories in the original packaging.
ü
The ABD is now ready to be transported.
8.1.2
Transport notes
Transport the ABD very carefully to prevent damage from impact, shock or vibration.
The ABD should be transported in such a way that major temperature fluctuations are
avoided and the formation of condensate is thus prevented.
Observe the safety notes in the user manuals of the analyzer.