Maintenance and care
Automatic Boat Drive
26
}
Using the face spanner, carefully tighten the clamping ring.
}
First mount the guide on which the ABD is aligned towards the basic
module. Then open the front doors of the basic module.
}
Turn the combustion furnace into the vertical position.
}
Push the guide under the right side of the basic module until the mount-
ing pins protrude through the front and rear ventilation slots in the floor
of the basic module (see arrows).
}
Place the perforated plates on the mounting pins of the guide and screw
the plates on loosely. The guide must still be movable.
}
Turn the combustion furnace into the horizontal position and insert the
combustion tube in the furnace.
}
Carefully move the ABD towards the basic module until the ABD connec-
tion piece and the combustion tube almost touch.
}
The connection piece and the combustion tube must be at the same
height so that both can be easily connected. If necessary, use the ad-
justable feet of the ABD to adjust the height.
NOTICE
Danger of glass breakage
Perform the height adjustment with care. The combustion tube must not be jammed or
be under stress during the subsequent coupling in the sample sluice.
}
Screw the two knurled screws onto the front attachment of the guide.
}
Carefully slide the ABD back on the guide. Be careful not to move the
guide. Pull the combustion tube out of the furnace.
}
Turn the furnace into the vertical position.