Endless Pools X2000 SwimCross, Owner'S Manual

Page: 23 / 36

Page 20 Operating Instructions
LIGHT CONTROL
All exercise systems are equipped with a lighting system. This system
includes interior points of lights located
throughout the spa side.
Press the
(lower right) button
(when in the home screen) to activate
all interior spa side lights and the light
icon. Press a second time to shut all
interior spa side lights and icon light
off, when turning back on after several
seconds the same light mode will
appear.
Every time the light is turned off and on quickly a new light mode will
appear.
The sequence is as follows: White, Aqua, Magenta, Azure, Amber,
Emerald, Ruby, color wheel with abrupt color changes, slow full color
wheel and fast full color wheel.
NOTE: If left on, the lights will automatically turn off after 4 hours of
operation.
FILTER CYCLES
When your spa side is first powered up, the default filter cycle is set to
start at 12:00 pm and 12:00 am and will run for 1 hour each day using
the
Beginner
Water Care mode. Unless you set the time using the
control panel (see Date & Time under Settings) the spa side filter cycle
will start at power up and run for 1 hours and repeat every 12 hours.
We recommend setting your date and time first, then going to the Water
Care section and making any desired changes for days, start times and
length of time in the desired Water Care Mode.
The spa side filter cycle will activate the circulation pump for the entire
cycle that has been programmed.
NOTE: Power interruption of the spa side will not change the filter cycle
settings when power is regained.
At the beginning of each filter cycle all jets on spa side will first run on
high speed for 1 minute (purge cycle) back to back.
FILTER CYCLE SUSPENSION:
The filter cycle will be suspended every time a jet pump or light
is activated manually during the filter cycle time. The suspension
will end 10 minutes after the completion of the manual use.
POLLING
Polling is necessary for your hot tub to maintain the proper set
temperature. The temperature probe located inside the heating tube
requires water from the hot tub to pass through it, this is done by
automatically turing on your filtration pump for approximately 2 minutes.
Outside temperatures will determine how often the pump is turned on,
this can range anywhere from 15 to 90 minute intervals.
ALL OFF / MEMORY ON
Press the (middle right) button
when in the home screen to turn the
lights and any jets that are on OFF.
If you press this button again before
pressing the light or jets button it
will bring up the last settings before
shutting off.
WI-FI IN.TOUCH (OPTIONAL)
If your spa side is equipped with the Wi-Fi in.touch module you will be
able to use the internet or your home Wi-Fi network to control you spa
side by downloading an App to your favorite devices.
See Wi-Fi in the Settings section to connect your spa side to your home
Wi-Fi network.
For instruction on how to download the App to your device search "gecko
in.touch" in your App store.
SMART WINTER MODE
The Smart Winter Mode (SWM) is used to prevent water from freezing in
the plumbing lines. As soon as there is a risk of freezing, this protection
automatically kicks in. The SWM protection will turn back off only after
24 hours without a risk of freezing. During the SWM period, the Smart
Winter Mode icon remains on; the icon blinks when the purge is active.
The purge period indicates the amount of time between the purging of
the plumbing lines based on the temperature behind the panels.