Emotron EMX-D, Instruction Manual

Page: 28 / 53

Emotron AB 01-5016-01r0 Operation via the Control Panel 21
6. Operation via the Control Panel
This chapter describes how to use the control panel.
6.1 General
The control panel displays the status of the VSD and is used
to set all the parameters.
6.2 The control panel
Fig. 16 Control panel
6.2.1 The display
The display is back lit and consists of 2 rows, each with
space for 16 characters. The display is divided into seven
areas.
The different areas in the display are described below:
Fig. 17 The display
Area A: Shows the actual menu number (3 digits).
Area B Indicates if the menu is in the toggle loop.
Area C Rotation monitor Indicators, flashing each time
rotation sensor is activated.
Area D: Shows the heading of the active menu.
Area E: Shows the status of the VSD (3 digits).
The following status indications are possible:
Acc
: Acceleration
D ec
: Deceleration
Run
: Motor runs
Trp
: Tripped
Stp
: Motor is stopped
VL
: Operating at Voltage limit
SL
: Operating at Speed limit
C L
: Operating at Current limit
T L
: Operating at Torque limit
O T
: Operating at Temperature Limit
LV
: Operating at Low Voltage
Area F: Shows A.
Area G: This area shows the value for active parameter
and rotation alarm or ---- if no signal from
rotation sensor.
Fig. 18 Example 1st level menu
Fig. 19 Example 2nd level menu
Fig. 20 Example 3d level menu
NOTE: The VSD can run without the control panel being
connected. However the settings must be such that all
control signals are set for external use.
LC Display
LEDs
Control Keys*
Toggle Key *
Function Keys
PREV NEXT ESC
ENTER
RESET
LOC/
REM
* Not used
100 Normal
Run 64,1rpm
T
A
A D
E G F
C B
700 Oper/Status
Stp
A
710 Operation
Stp
A
717 Output Volt
Stp
M1: 400V
A