___________________________________________________________________________________________________
_________________________________________________________________________________________
Page 7 / 30 EZM7750_ENG_VER11
2 INSTALLATION:
χχ
WARNING:
1- A visual inspection of this product for possible damage occurred during shipment
is recommended before installation. It is your responsibility to ensure that qualified
mechanical and electrical technicians install this product.
2- If there is danger of serious accident resulting from a failure or defect in this unit,
provide the unit with an appropriate external protective circuit to prevent an
accident.
3- The unit is normally supplied without a power switch or a fuse. Use power switch
and fuse as required (fuse rating is 1A@250VAC)
4- Be sure to use the rated power supply voltage to protect the unit against damage
and to prevent failure.
5- Keep the power off until all of the wiring is completed so that electric shock and
trouble with the unit can be prevented.
6- Never attempt to disassemble, modify, or repair this unit. Tampering with the unit
may results in malfunction, electric shock, or fire.
7- Do not use the unit in combustible or explosive gaseous atmospheres.
8- During the equipment is putted in hole on the metal panel while mechanical
installation some metal burrs can cause injury on hands, you should be careful.
Installation parts of equipment should be tighten properly. The equipment can be
drop from mounting place reason of vibration if installation parts leave soft.
χχ
WARNING: Before beginning installation of this product:
-
Disconnect all electrical power to the machine.
-
Make sure the machine cannot operate during installation.
-
Follow all safety warnings of the machine manufacturer.
Read and follow all installation instructions.
2.1 General Description:
Panel Surface (max thickness 15mm)
Front Panel
IP65 protection
NEMA 4X
Mounting clamps
Product label
Terminal protection cover
DIP Switch cover