Emerson Rosemount 326P, Quick Start Manual

Page: 19 / 48

Table 3-1: Extended functions menu options
Option Description
Uni Standard unit of measurement for system pressure
SELd Display mode:
1. Pressure in the unit set in Uni
2. Pressure in percent of the set scaling of the analog output
ASP Analog start point for system pressure: measured value at which 4 mA is
provided (20 mA if OU2 = InEG)
AEP Analog end point for system pressure: measured value at which 20 mA is
provided (4 mA if OU2 = InEG)
HI Highest measured system pressure
LO Lowest measured system pressure
COF Zero trim
dS1
(1)
Switch-on delay for OUT1
dr1
(1)
Switch-off delay for OUT1
dS2
(1)
Switch-on delay for OUT2; only active if OU2 = Hnc, Hno, Fnc or Fno
dr2
(1)
Switch-off delay for OUT2; only active if OU2 = Hnc, Hno, Fnc or Fno
FOU1
(1)
Status of output 1 in case of an internal fault
FOU2 Status of output 2 in case of an internal fault
P-n
(1)
Switching logic for the outputs: pnp or npn
dAP Damping for switching outputs and display
dAA Damping for analog output (OUT2)
diS Update rate and orientation of the display
CAL Calibration function (setting the curve of measured values)
CP1 Calibration point 1
CP2 Calibration point 2
SIM Switch to the simulation menu (level 3)
rES Restore factory default settings
(1) Not active in a two-wire operation.
Quick Start Guide Operation
00825-0100-4327 January 2019
Quick Start Guide 19