31
Section 7: Control Unit
User Instructions
MAN-02-04-60-0351-EN Rev. 3
February 2019
Control Unit
Table 4.
Selector Switch Position Table
Selector switch in the
OFF position:
The control switch is used to scroll up or down the menu
according to internal symbolism. From the neutral position
towards you reach the status and history data areas.
Towards the symbols you reach the parameter menu. Here, the
selection switch either confirms or rejects the
current input according to associated symbolism.
Selector switch in the
REMOTE position :
The control switch gives you access to status, history data and
parameter area.
Selector switch in the
LOCAL position :
With the control switch, the actuator can be operated by motor.
You may also operate the actuator in inching and self-hold mode.
Switches are spring-loaded to snap back automatically into their
neutral position. (To confirm a control command, the control switch
must be pushed all the way into its mechanical locking position.)
7.3.2 Configuration
In principle, all parameters are shown as numbers in the corresponding parameter point.
From the actuator menu, use the control switch to access different menu points. The lower
left corner of the display shows the "EDIT?" option.
Figure 40
Display (11)
Confirm the selector switch with a slight flip towards , (see Figure 24 to Figure 28) to
change the selected parameter. To confirm this input readiness, the display changes from
"EDIT?" to "SAVE?".
Figure 41
Display (12)
