EMC VPLEX, Installation And Setup Manual

Page: 34 / 94

EMC VPLEX with GeoSynchrony 4.1 Installation and Setup Guide 34
Setting up VPLEX
9. Open a Command Prompt window ( Start > Programs > Accessories > Command
Prompt ), and type the following command to confirm the settings:
ipconfig
Output example:
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix . : eng.emc.com
IP Address. . . . . . . . . . . . : 128.221.252.3
Subnet Mask . . . . . . . . . . . : 255.255.255.224
Default Gateway . . . . . . . . . : 128.221.252.2
10. Type the following command to verify that you can reach the management
server’s service port:
ping 128.221.252.2
11. On your laptop, launch PuTTY.exe .
Note: If you see a PuTTY security alert, read it, and then click yes .
12. Configure the PuTTY Configuration window as shown in Figure 21 .
Figure 21 PuTTY settings for VPLEX_service session
13. Select SSH in the Category list, and ensure that Preferred SSH protocol version
is set to 2 , as shown in Figure 22 .
P u TTY
Type:
128.221.252.2
(defa u lt)
(defa u lt)
Type session name:
VPLEX_service