13
9.3.2. POWER CONTROLLER
Power controller regulates the chlorine generates by the cell and is
introduced into the pool water.
Two different options are available:
STANDARD CHLORINE PRODUCTION
The higher is the % of power output, the higher amount of chlorine will
produce the system up to the maximum cell’s capacity.
The range of % output power is lighting in red, from 0% until the desired
value.
For setting the desired output power, press the b or – to increase
or decrease the value respectively. The new value will be flashing until the
system reaches to it.
The system will NOT generate chlorine in the following situations:
a)
The Indicator AUTO is not switched on.
b)
The current time is out of the programmed schedules.
c)
The flow sensor from the cell does not detect flow rate.
d)
SSC
one
®
unit is switched off.
BOOSTING CHLORINE
Sometimes, after a higher load of bathers, heavy rain, pool water
renewal, etc. the chlorine concentration drops down
considerably.
In this cases, by using BOOST button, the Emaux
SSC
one
®
will
generate chlorine at 100% of output power during 24 hours or
until the same button is pressed again by the user.
How to proceed:
1.
Before Boosting chlorine, it is recommended checking the chemical parameters, paying
special attention to the pH, which should be between 7.2 and 7.4.
2.
By pressing BOOST button in the POWER Controller, the green LED lights will go red and
BOOST signal will go green. Consequently, the filtration pump will switch on and the output
power will be slowly increasing up to 100% of production.
The time schedule will change to red color and will operate for 24 hours non-stop, unless
the operation is cancelled by pressing the button BOOST again.
During Boosting chlorine, it is recommended check the chlorine concentration more often
because it may increase fast in a short period of time.
3.
After boosting chlorine, the unit will keep working according to the previously programmed
schedule.
