Elster EK220, Operating Instructions And Installation Information, Page: 44 / 120

Volume Conversion Device EK220
44 © Elster GmbH
3.8 Status list
The values shown in this list depend on the set the functionality of certification data log PL
(see page 58):
a) Functionality of certification data log activ, PL = 1 ("on") :
AD Designation / value Unit Access Address DC
S.Reg Status register, total - (S) 1:101 19
Stat Momentary register, total - - 1:100 5
Clr Clear status register - S 4:130 2
Logb. Logbook - (S) 4:A30 8
AudTr Audit trail - (S) 5:A30 8
PLogB Certification data log (calibration logbook) - - 9:A30 8
ClrPL Clear certification data log - C 9:A52 2
b) Functionality of certification data log inactiv, PL = 0 ("off") :
AD Designation / value Unit Access Address DC
S.Reg Status register, total - (S) 1:101 19
Stat Momentary register, total - - 1:100 5
Clr Clear status register - S 4:130 2
Logb. Logbook - (S) 4:A30 8
AudTr Audit trail - (S) 5:A30 8
(Legends: see page 22)
S.Reg Status register, total
Stat
Momentary register, total
The EK220 supplies two types of status information: Momentary status (also known
as "status") and the status register.
Messages in the momentary status point to current statuses such as for example, e r-
rors that are present. When the state is no longer present, the corresponding me s-
sage in the momentary status disappears. Manual deletion is not possible.
Alarms, warnings and reports (i.e. messages with numbers in the range from "1" to
"16") are displayed in the momentary statuses.
- In the status register all messages since the last manual clearing are collected. Here,
you can also see what has happened, for example, since the last station inspection.
The messages can be cleared in this list with the command "Clr".
Only alarms and warnings (i.e. messages with numbers in the range from "1" to "8") are
displayed in status registers. Reports are not entered because they identify states
which are not problematical or may even be intended (e.g. "Daylight saving", "Calibra-
tion lock open" or "Data transfer running").