10
Installation and start-up
Weather Station Suntracer KNX sl
• Status: 14.07.2016 • Errors excepted. Subject to technical changes.
2.3. Device design
2.4. Installing the weather station
ATTENTION!
Even a few drops of water can damage the device electronics.
•
Do not open the device if water (e.g. rain) can get into it.
1
Fig. 5
1
GPS receiver in lid
2
Programming LED
3
Brightness measurement
4
Precipitation sensor in lid
5
Temperature measurement
6
Wind measurement
7
Programming key on the underside of the housing (recessed),
see
Addressing the
equipment, page 15
8
Air pressure sensor in housing
ATTENTION!
Sensitive wind sensor.
•
Remove the protective transport sticker after installation.
•
Do not touch the sensor on the wind measuring element (no. 6).
5
6
8
2
3
4
7
