![background image](http://html1.mh-extra.com/html/elsner-elektronik/knx-aqs-th-b-up/knx-aqs-th-b-up_installation-and-adjustment_2396600028.webp)
27
Parameter setting
Sensor KNX AQS/TH-B-UP
• as of software 3.1 • Version: 01.03.2017 • Technical changes and errors excepted.
Determine when the current settings of the controls are to be transmitted to the bus.
Periodic transmission is safer if a message does not reach a recipient. You may also
set up periodical monitoring by the actuator with this setting.
The status object shows the current status of the output variable (0 = OFF,
>0 = ON) and may, for example, be used for visualisations or to switch off the heating
pump as soon as the heating is off.
Then define the type of setting. Heating and/or cooling may be controlled in two levels.
Mode after reset
• Comfort
• Standby
• Eco
• Building protection
Behaviour of the blocking object at value
• 1 = block | 0 = release
• 0 = block | 1 = release
Blocking object value
before 1st communication
0 • 1
Send actuating variables
• on change
• on change and periodically
cycle
for periodical transmission only
5 s • ... • 5 min • … • 2 h
Send status objects
• on change
• on change to 1
• on change to 0
• on change and periodically
• on change to 1 and periodically
• on change to 0 and periodically
cycle
for periodical transmission only
5 s • ... • 5 min • … • 2 h
Type of control
• One-stage heating
• Dual-speed heating
• Single-speed cooling
• Dual-stage cooling
• Single-speed h Single-speed cool-
ing
• Dual-speed h Single-speed cool-
ing
• Dual-speed h Dual-speed cooling
Summary of Contents for KNX AQS TH-B-UP
Page 5: ...4 Clarification of signs...