![background image](http://html1.mh-extra.com/html/elsner-elektronik/knx-aqs-th-b-up/knx-aqs-th-b-up_installation-and-adjustment_2396600023.webp)
22
Parameter setting
Sensor KNX AQS/TH-B-UP
• as of software 3.1 • Version: 01.03.2017 • Technical changes and errors excepted.
5.
Parameter setting
5.1.
Behaviour on power failure/ restoration of
power
Behaviour following a failure of the bus power supply:
The device sends nothing.
Behaviour on bus restoration of power and following programming or reset:
The device sends all outputs according to their send behaviour set in the parameters
with the delays established in the "General settings" parameter block. The "Software
version" communications object is sent once after 5 seconds.
5.2.
General settings
Set the basic data transfer characteristics and select whether or not malfunction ob-
jects should be sent.
5.3.
Measured values: Temperature, humidity,
CO2
The setting options for temperature, humidity and CO2 readings are the same.
Use
Offsets
to adjust the readings to be sent.
The unit can calculate a
mixed value
from its own reading and an external value. Set
the mixed value calculation if desired.
Send delay after power-up and programming for:
Measured values
5 s • ... • 2 h
Threshold values and switching outputs
5 s • ... • 2 h
Controller objects
5 s • 10 s • ... • 2 h
Logic outputs
5 s • 10 s • ... • 2 h
Maximum telegram quota
• 1 message per second
• ...
• 5 messages per second
• ...
• 20 messages per second
Use temp./humidity malfunction object
Yes • No
Use CO2 malfunction object
Yes • No
Temperature
: Offset in 0.1°C
Humidity
: Offset in % rH
CO2
: Offset in ppm
-50…50; 0
-10...10; 0
-100...100; 0
Use external reading
Yes • No
Summary of Contents for KNX AQS TH-B-UP
Page 5: ...4 Clarification of signs...