Elpro Technologies CONDOR 415U-1 Series, Configuration Manual

Page: 19 / 41

User Manual Condor 415U-1-Cx Battery Powered Wireless IO
Version 1.4 19
See below for an example of the I/O and the use of multipliers.
I/O Quick Setup Mapping example for configuration of 3 stations:
Configuration Values Example Units
Input Name Input
Type Register
Values Register Type Remote 1
Multiplier Remote 3
Multiplier Remote 10
Multiplier
Discrete input 1 Pulsed 37011 Unsigned 32 Bit 37011 37031 37101
Discrete input 2 Pulsed 37013 Unsigned 32 Bit 37013 37033 37103
Discrete input 3 ON/OFF 15010 Unsigned 16 Bit 15010 15030 15100
Discrete input 4 ON/OFF 15011 Unsigned 16 Bit 15011 15031 15101
Analog Input 1 4-20mA 35010 Unsigned 16 Bit 35010 35030 35100
Analog Input 2 4-20mA 35011 Unsigned 16 Bit 35011 35031 35101
Battery Vdc 39011 Float 39011 39031 39101
Sup/Sol Vdc 39013 Float 39013 39033 39103
RSSI dBm 39015 Float 39015 39035 39105
Status Bit Field 35012 Unsigned 16 Bit 35012 35032 35102
Access Point Register (REG) Address Values
If manually configuring the AP register it is recommended for application to use the standard Modbus
convention for REG address values used in the application. REG values can be set to a value up to a
maximum of 65535 and a value of 0 (zero) is used to disable a sensor REG where it is not used so that
no data is transmitted.
Below is a listing of REG address ranges that are recommended for use in a 415U-E-Cx or 415U-2-Cx
units when used as the AP for the 415U-1-Cx unit.
Input Type REG Address Range REG Area Value Type
Discrete inputs 10406-20000 General Purpose Bit Storage Single bit
Word Inputs 32256-36000 General Purpose Word Storage Unsigned 16 bit
Long Inputs 36001-38000 General Purpose 32-bit Storage Unsigned 32 bit
Float Inputs 38001-40000 General Purpose Floating Storage Float 32 bit
Sensor input configuration is best completed after you have configured the Unit Config and
Communications as selected from main menu. It is recommended to use the I/O Quick Setup in the
Unit Config menu as well as it is a very fast way to setup basic IO configuration.
Once you have this basic setup completed then access the input setup through I/O Setup option from
main menu. This menu is displayed as shown below.
The current status of inputs will be displayed in the header of this menu. Sensor ID of 255 is used to
disabled/unused sensor and will have values that are bracketed with # and ID indicated with
– as
shown below.
External Inputs
DI1 DI2 DI3 DI4 AI1 AI2
REG 37031 37013 15010 15011 35010 35011
Format U-4 U-4 ELPRO ELPRO ELPRO ELPRO
Raw 0 0 On Off 0 mA 0 mA
Value 0 0 65535 0 8192 8192
External Outputs
DO1 DO2
Mode ON/OFF ON/OFF
REG 10001 10008
Sens 100 100
Value 0 0
I/O Setup Menu: