Elma Schmidbauer GmbH
About this manual |
Elmasonic Med
25 / 32
Press the
Start/Stop
button to begin ultrasound operation in the displayed mode.
The
Remaining time
symbol is shown on the display. The remaining time, the
current temperature and the set ultrasound mode are continuously shown on the
display.
The ultrasound mode, temperature, duration and heating
On/Off
can be changed
during ultrasonic cleaning.
Important
Changing the duration switches off ultrasonic
cleaning. Press the
Start/Stop
button to restart ultrasonic cleaning with the altered
time setting.
The
End of cleaning
symbol and, where applicable, an acoustic signal (depending
on the configured parameters) indicate that cleaning has ended. The
Remaining
time
display will disappear.
12.2
Programme mode
Start stored programmes.
A programme must be saved in at least 1 of 4 possible programme numbers.
The unit is in
Programme
mode. The last-used programme number is shown on the display.
The unit is in
Normal
mode. No programme number is shown on the display.
Switch between Normal mode and Programme mode, if applicable:
Hold down the
Mode
button until a programme number is shown on the display. The
last-used programme number is always shown, e.g. programme number 3.
Start stored programmes:
Press one of the
Plus/Minus
buttons to select a programme.
Press the
Start/Stop
button to start the displayed programme. The
Remaining time
and
Heating
symbols will be shown on the display (if saved). The remaining time,
the current temperature and the ultrasound mode are continuously shown on the
display.
IMPORTANT
Depending on the settings saved in the programme, ultrasonic
cleaning is started with
Auto-degas
(
Degas
flashes) or
Temperature-controlled start
(only starts once the target temperature has been reached). The respective symbols
are shown on the display.
The end of cleaning is indicated by the
End of cleaning
symbol and, where
applicable, an acoustic signal (depending on the parameter settings). The
Remaining time
display will disappear.
