| About this manual
Elma Schmidbauer GmbH
24 / 32
Elmasonic Med
Ensure that the required target temperature is higher than the current actual temperature. If not,
allow the fluid to cool.
Ensure that the unit is not in ultrasound operation.
Hold down the
Heating
button until the
Temperature-controlled start
symbol flashes
on the display.
Press the
Start/Stop
button to start the unit using the temperature-controlled start
function.
See the section
Save programmes
for information on saving the
Temperature-
controlled start
function as a programme.
The display shows the
Temperature-controlled start
and
Heating
symbols. The display
shows the set target temperature and the current actual temperature of the cleaning
fluid flashing alternately.
During the heating phase, the ultrasound is switched on briefly multiple times to
ensure that the fluid is heated evenly.
The ultrasonic cleaning function will start once the set target temperature has been
reached. The
Temperature-controlled start
symbol will disappear.
Save programmes
(programme numbers 1–4)
:
Settings have been configured in
Normal
mode. These settings can be saved as a programme.
Important
The
Auto-degas
and
Temperature-controlled start
modes can only be saved separately as
programmes.
Hold down the
Mode
button until the display shows all 4 programme numbers and
programme number 1 flashes. Now, press one of the
Plus/Minus
buttons repeatedly
until the programme number in which you wish to save your settings flashes. Press
the
Mode
button again briefly to confirm saving the programme. The set programme
number will be shown on the display.
Switch off and save:
The displayed settings are saved when the unit is switched off and are then available the next time
the unit is switched on. This function cannot be used to save
Auto-degas
and
Temperature-controlled
start
.
Press the
On/Off
button to switch off the unit. Any settings made will be saved until
the next time the unit is switched on.
Start Normal mode:
The described settings have been configured, and you now wish to start them.
If necessary, press the
Heating
button to heat the cleaning fluid. The
Heating
symbol
will be shown on the display. The display shows the set target temperature and the
current temperature of the cleaning fluid flashing alternately. If necessary, wait until
the target temperature has been reached.
