| About this manual
Elma Schmidbauer GmbH
22 / 32
Elmasonic Med
Two modes can be selected for starting ultrasound operation: Select
Normal mode
to set the duration,
ultrasound mode and temperature, to start operation or save programmes. Select
Programme mode
to
select and start a stored programme. The unit is in
Programme
mode if a programme number is shown
on the display.
Switch on the unit:
The unit is ready to use.
The unit is filled, and the objects being cleaned have been inserted.
The unit is covered with the lid.
Press the
On/Off
button to switch on the unit. The display shows the last-used
settings, e.g. duration, ultrasound mode, current temperature and, if applicable, the
stored programme number.
Switch between Programme mode and Normal mode:
Important
If
Programme
mode is selected, switch to
Normal
mode.
Normal
mode must be active to
configure the ultrasonic cleaning settings.
Press the
Mode
button for 2 seconds to switch between
Programme
and
Normal
mode. The programme number shown on the display will disappear, and
Normal
mode will be activated.
12.1
Normal mode
Normal
mode is used to start previously configured ultrasound operation, to change settings during
ultrasound operation, or to save programmes.
Start ultrasonic cleaning:
Cleaning starts with the settings shown on the display.
For information on changing the settings, see
Set cleaning duration, ultrasound mode and target
temperature
.
Press the
Start/Stop
button to begin ultrasonic cleaning. The
Remaining time
symbol
shows that the unit is operating. The current remaining time, the current temperature
and the ultrasound mode are continuously shown on the display.
Press the
Start/Stop
button again to stop operation prematurely. The
Remaining time
symbol will disappear.
The
End of cleaning
symbol and, where applicable, an acoustic signal (depending on
the configured parameters) indicate that cleaning has ended. The
Remaining time
display will disappear.
