Elliott Digger Derrick, Operation & Maintenance Manual, Page: 332 / 376

15
DM-R2170-0002A
www.omnexcontrols.com call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash Fast
Flash Red
Light Green
Light Alternating Red
& Yellow Light Yellow
Light
The transmitter’s Paddles control the receiver’s proportional output. The Paddles/Joysticks are used in conjunction with
any of the transmitter’s switches. The proportional output can be activated when a switch is held UP or DOWN; it will be-
come active at an increasingly high level as the Paddle/Joystick is pushed/pulled. The minimum and maximum levels of
the proportional output can be calibrated by following these steps.
Refer to the Light Legend below for diagram details.
NOTE: Calibration settings can be reset to factory default in steps 3 & 4 by holding the [Power] switch UP or DOWN for 5 seconds
.
A. Refer to steps in “Power the
Transmitter”
B. Supply power to the R2170
B.
1. Power T2300, Power R2170
A. Hold [Power] switch DOWN
for 5 seconds until the
(Battery) LED goes to alter-
nating RED and YELLOW.
B. Release [Power] switch
2. Setup T2300 for Output Calibration
3. Set Minimum Level
4. Set Maximum Level
5. Power Off
A. Press [E-Stop]
A.
A.
B.
A.
A.
B.
B.
Note:
Repeat steps 3 and 4 for each paddle (function) that needs to be calibrated.
A.
Calibrating Proportional Controls
A. Push the paddle (function) in the
direction you wish to calibrate
until the (Active) LED comes on
B. Hold paddle and Press [Power]
switch UP to decrease minimum
level or DOWN to increase it
A. Fully push the paddle (function) in
the direction you wish to calibrate
until the (E-Stop) LED comes on.
B. Hold paddle and Press [Power]
switch UP to decrease maximum
level or DOWN to increase it
STATUS
LINK
ESTOP
CAN 1
CAN 2