Elliott Digger Derrick, Operation & Maintenance Manual, Page: 330 / 376

13
DM-R2170-0002A
www.omnexcontrols.com call toll free: 1-800-663-8806
CAN 2
CAN 1
ESTOP
LINK
STATUS
CAN 2
CAN 1
ESTOP
LINK
STATUS
A. Hold [Power] switch UP
B. Press [E-Stop]
C. Twist CW & release [E-Stop]
D. Release [Power] Switch
4. Power T2300 into Configuration
D.
B.
A.
C.
0
5. Download ID Code
A. Press [Power] switch UP
and release
B. (Link) light goes to GREEN
during download.
C. Once complete, (Link) light
goes to RED as the transmit-
ter turns off
B.
A.
C.
NOTE: A transmitter ID may be downloaded at anytime even if the R2170 already has a valid
transmitter ID—the new ID will simply overwrite the previous ID. When the R2170 enters Setup
Mode, it shuts down the CAN ports and opens the Emergency-Stop Relay, thus disabling normal
operations.
If, for some reason, [SW 1] or [SW 2] is stuck “on”, the R2170 will indicate this fault by flashing its
(Status) and (Link) lights RED, and also flash its (CAN 1) light GREEN. (Refer to the R2170
Diagnostic page for more details
CAN 2
CAN 1
ESTOP
LINK
STATUS
Stuck Buttons
NOTE: When downloading a new ID to a receiver, a safety feature requires that the transmitter be in close proximity to the receiver.
This will prevent a transmitter from accidentally reprogramming a different receiver in the area.
NOTE: When replacing the receiver cover, ensure the cover snaps completely into place to create a weather proof seal
around the base of the receiver.
Downloading the Transmitter ID (continued)