3
Customer Setup & Installation Requirements
Overview
24VDC power must also be supplied to the eWON router.
The eWON router needs access to the internet. This access can be achieved either through a wired Ethernet
connection, or a wireless (WIFI) connection.
It also needs to be connected to the Elkhart Brass Monitor network. This connection will be a wired Ethernet
connection.
Installation / Assembly / Power
Step 1: Mounting the eWON (optional)
For convenience, you may mount the router on an unused section of din rail. Slide the clear rail clip on the back
of the router down until it clicks into the open position. Install the router onto the din rail and then push up on
the clip untill it clicks and locks the router onto the din rail.
Step 2: Antenna Installation (required for WIFI use):
Install the antenna onto the router by hand tightening it on to the brass connector on the front of the router.
Step 3: Power
Connect power as shown.
•
Connect 24VDC+ from term [51] or [51A] to the [+] terminal on the removable green connector on top
of the eWON.
•
Connect 24VDC- from term [52] to the [-] terminal on the removable green connector on top of the
eWON.
•
Add a ground wire to connect both of the ground connections, as shown.
