PARTITION
If you have purchased a partition it is at this point you construct the frame in situ. In the box you
will find packs marked
Partition corner bars
Partition door end cill
Partition door end
Partition door tracks
Partition door panels
Partition door posts
You will also require a number of fittings from the box:
1 gusset plate
Glazing beading
Nuts and bolts
PROCEDURE
1. Starting with the corner bars, identify the roof and side, left and right hands as you did earlier.
2. Each corner bar has a saw cut approx. 20mm into the bar from each
end, but apart from that they are identical. Insert the glazing beading as
before – but this time into all 3 grooves of the corner bar.
(Key point).
3. Having established where the partition is going you will need to
make the holes in the gutter, ridge and cill into slots. Do this by careful-
ly hack sawing down into the hole to form the slot.
(Key point).
4. If the doors on your partition are to face the rear end, then the bolt channels on the roof and side
corner bars must face the front door. (For partition doors facing front door, the bolt channels of the
corner bar must face the rear end.
5. Take the side corner bar, insert 1 bolt into each end of the alternative bolt slots, then offer it up
to the eave/gutter and cill so that the flange of the cill and the eave are inserted into the saw cut.
(Key point).
Loosen the bolts just inserted and lower into the slot on the gutter and bottom cill and
finger tip tighten.
6. Repeat for the roof corner bars, but insert 6 bolts into the alternative bolt channel. 1 each end
and 4 in the middle to attach to the top hat sections.
7. Next, offer the gusset plate to the corner bars at the point where they meet. Slide the bolts in the
facing bolt slot towards the gusset plates and line up the holes in the gusset plate with the bolts in
the facing bolt slot and in the flange of the corner bar. Insert 2 bolts through the gusset plate and
flange (middle 2 holes), put a nut on – finger tip tight. Do not put the nuts on the upper and third
bolts of the eave gusset plates at this stage.
(Key point).
8. The cill can now be attached to the facing bolt slot of the partition corner bar (in the same way
you did during the original door end assembly).
9. You can now attach the two vertical glazing bars and wall bar. Thread the glazing beading into
the channels and trim to suit. Follow instructions earlier in the plan related to building a gable with
doors.
For both double and partition-door ends you can now fit the upper door track.
Summary of Contents for TITAN K800
