Elite Greenhouses TITAN K800, Instructions & Illustrations

Page: 12 / 36

SHELF FITTING
The standard shelf is intended to fit on the rear gable end or side of the greenhouse. Not only is it
very useable, but it adds lots of strength to the greenhouse.
The parts required for the shelf are:-
Top slat sections x 2
Cantilever braces x 5
Angle brackets x 4
Angle supports x 5
Nuts/bolts
You must decide the height you want your shelf to be fitted. Fix one angle support to each vertical
glazing bar at the desired height utilising the pre-inserted bolts. Do not fit the angle support to the
corner bar yet. Fix an angle bracket to the corner bars at the same height as the angle support, and
another angle bracket to the same corner bar approx. 200mm below the 1st. Note, the orientation of
the angle bracket in the diagram.
Attach the angle supports to the angle brackets with the square edge against the greenhouse wall.
(chamfered edge sticking out). The angle support must be fitted to the slot closest to the fold on the
long side of the angle bracket.
Fix a cantilever bar to each vertical glazing bar approx. 200mm below the angle support, and also to
the lower angle bracket on the corner bar.
Slide 1 bolt per angle support into the bolt channel on the underside of each top slat, and line up
with the slots in each angle support. When attaching the slat to the mitred end of the angle support,
you must also attach the unoccupied hole at the end of the cantilever brace to the same position.
NB. The tee bar cantilever is a universal part used in the greenhouse for other purposes and shelves.
If the angle appears slightly ‘out’ it can easily be moved into position by altering the angle with a
pair of pliers, if necessary.