Elite Greenhouses 6'3" WIDE THYME, Instructions & Illustrations, Page: 6 / 36

INSTALLATION INSTRUCTIONS FOR THE 6’3” WIDE
“THYME” MODEL RANGE (Dwarf wall and Built in Base model)
The contents of this carton are divided into the different frame assemblies that collectively
make up the completed greenhouse framework.
It is recommended that each framework assembly is fully completed before moving onto the next.
The contents are as follows:
1 Two side frames
2 Rear end frame
3 Door end frame
4 Roof vents (number dependant upon length of greenhouse)
5 Doors
6 Bag of fittings containing:
·
Nuts and bolts general assembly
·
Clips for glass
· Casement stays for vents (1 per vent)
·
Casement stay nuts and bolts
·
Four eave plates (taped with the casement stay)
·
Two ridge plates
·
Two door wheels
·
Two door guides
·
Small self tapping screws
·
1 Double door lock + cam
7 Roof bars
8 Coils of glazing beading
9 One length of ridge
10 Two black brush draught excluders inc. carrier
For clear identification of parts and the number required please carefully refer to the earlier
pages of component drawings and parts list.
If your greenhouse is a dwarf wall model, the side cills will be the full length of the building
(up to 20’).
If your greenhouse is over 12’5” long the longer built in base side walls will be in 2 pieces (one of
which will be an 8’ extension piece) which you join together by using one extra base leg/corner
bracket at the “middle end” of each side piece. The base legs in the middle return on themselves and
butt up to each other to form a ‘T’. Bolt them together to form a longer solid side e.g. 14’, 16’, 18’
or 20’. Bolt both angles together via the ‘spare’ hole.
IMPORTANT: If you plan to erect the
greenhouse on a patio or flagged area, you need
to insert some extra bolts in the bolt channels,
(generally 1 every 2’). These will be used to
anchor the greenhouse to the floor later in the
assembly. Also if you have ordered a partition,
slide 1 extra bolt into the bolt slots of the built in
base.