40
English
Check :
Check that the rear of each blade is towards the wall of the shredding cham-
ber. If this is not the case, correct the blades that are incorrect.
Changing the blades of group 2. (4 knife discs)
• Disassemble two blades that are diametrically opposite each other. Ro
-
tate them through 180° and change them over. Do the same with the two
remaining blades. Repeat this operation for the three remaining blade
disks of group 2.
Check :
The front side (bevelled edge) of each blade of group 2 mounted on a
fluted part of a blade disc must point towards the centre axis. When this is
not the case, adjust.
B. To renew a shredding knife, proceed as follows.
• New sets of knives are available form your ELIET Dealer under the following part number :
STD blades: BU 401 300 201
Resist
TM
blades : BU 401 300 302
• When renewing the blades, simply remove the old blades and replace them with new blades.
• First remove any dirt between the blade plates before you insert a new blade. To do so, use a
stripping knife.
• Use the same procedure as for reversing the blades. See checks for both groups.
• On renewing shredding knives, always fit new bolts and nuts.
Summary of Contents for MA 006 010 113
Page 1: ...Superprof M A N U A L...
Page 2: ...2 English...
