26
English
Warning :
Do not lean forwards to push material further into the loading hopper
so that your hands NEVER go past the safety screen.
• By reducing the amount of material that you feed into the machine, it will operate more opti
-
mally.
• In the case of branches, it is recommended to feed in the thickest part of the branch first.
• It is preferable to feed thick branches into the left-hand side of the loading hopper.
• You can determine the feeding-in speed as follows:
- Without ABM: You listen to the sound of the engine: if you hear
that the engine speed decreases substantially, this indicates that
the engine is encountering problems (speed decreases below 2500
rev./min.). If this happens, stop the material from being fed in by
moving the control handle away from you (position 3). When the
engine returns to its normal speed, you can restart the feed roller by
moving the control handle to the centre position (position 2).
- With ABM: The feed roller stops when engine speed is too low (<
2750 rpm) ; the green warning light (1) lights up. When the engine
returns to its normal speed, restart the feed roller.
- With speed governing : If you selected this option (rotary knob un-
derneath the loading hopper), you can control the speed of the feed
roller according to the material to be fed in. By adjusting the knob (in
the range of 1 to 10), you can obtain maximum efficiency.
• By pulling the control handle to position 1, the feed roller changes
direction. This is useful if a piece of wood becomes wedged under-
neath the feed roller.
• To stop the material from being fed in, push the control handle to
position 3.
• If the amount of chippings block off the output opening, move the
machine backwards. The pile may not be higher than the bottom of
the rear flap.
Summary of Contents for MA 006 010 113
Page 1: ...Superprof M A N U A L...
Page 2: ...2 English...
