46
English
B. Greasing via the grease zerks fitted
This group includes the following locations on the machine:
Grease zerk on the pivot point of feed roller (1)
Grease zerks on pivot point of castors (2)
Grease zerks on the bearings of the castors (3)
Grease zerks on the track guide bearings (Cross Country
model)
Use the following procedure :
• Clean the grease zerk.
• Using a suitable grease pump, apply new grease.
• ELIET recommends Sunoco Multi Purpose Grease.
• Pumping the grease gun one or two times is sufficient to
distribute the grease.
• Wipe away any grease that comes out of the joints.
C. Lubricating the bearings
This group includes the following locations on the
machine:
Bearing of the feed roller
Bearing of the knife drum
Use the following procedure :
• Spray some penetrating oil containing molyb
-
denum disulphide into the bearing and the area
around and allow the oil to penetrate.
• Wipe away any external dirt.
• Spray more penetrating oil into the bearing joints.
• Allow the bearing to rotate (possibly by starting the drive that moves the bearing). (CAUTION:
make sure that all dangerous zones are adequately shielded).
• Once again, wiped away any dirt that is forced out by the penetrating oil.
Summary of Contents for MA 006 010 113
Page 1: ...Superprof M A N U A L...
Page 2: ...2 English...
